Differences

This shows you the differences between two versions of the page.

--- router_setup_instructions [2010/03/23 13:48]
admin old revision restored
+++ router_setup_instructions [2011/04/26 15:16]
gabe
@@ Line 234: / Line 234: @@
 where 192.168.17.0 is the wired LAN.  you won't be able to ping 192.168.17.1, but traffic will still flow through it
+===== separating wifi & wired networks ("breaking the bridge") =====
+You'd want to do this if you want wifi users to authenticate to wifidog, but for computers plugged into the ethernet ports to not have to authenticate.
+The original config on the router is probably:<code>
+lan_ifname="br0"
+lan_proto=static
+lan_ipaddr=192.168.1.1
+lan_netmask=255.255.255.0
+wifi_ifname=""
+wifi_proto=""
+wifi_ipaddr=""
+wifi_netmask=""
+lan_ifnames="vlan0 eth1 eth2"
+</code>
+Run these commands:<code>
+nvram set lan_ifname=vlan0
+nvram set lan_proto=static
+nvram set lan_ipaddr=192.168.2.1
+nvram set lan_netmask=255.255.255.0
+nvram set wifi_ifname=eth1
+nvram set wifi_proto=static
+nvram set wifi_ipaddr=192.168.1.1
+nvram set wifi_netmask=255.255.255.0
+nvram set lan_ifnames=vlan0
+nvram commit
+</code>
+Edit /etc/dnsmasq.conf, adding these lines:<code>
+dhcp-range=eth1,192.168.1.100,192.168.2.250,255.255.255.0,12h
+dhcp-range=vlan0,192.168.2.100,192.168.2.250,255.255.255.0,12h
+</code>
+Edit /etc/wifidog.conf, and change "GatewayInterface" to eth1
+Reboot
+(Done!)

Wireless Toronto